Specifications
Engine
- Net Power - SAE J1349
- 538HP
- Engine Model
- Cat® C18 ™
- Engine Power - ISO 14396
- 580HP
- Gross Power - SAE J1995
- 588HP
- Rated Speed
- 1,700 rpm
- Emissions
- U.S. EPA Tier 4 Final, EU Stage V, and Japan 2014
- Peak Power Speed
- 1,500 rpm
- Bore
- 5.7in
- Stroke
- 7.2in
- Displacement
- 1105in³
- Peak Torque - 1,200 rpm - SAE J1995
- 2230ft·lbf
- Torque Rise
- 58%
Operating Specifications
- Operating Weight
- 116362lb
- Operating Weight - Standard
- 116362lb
- Operating Weight - High Lift
- 119618lb
- Rated Payload - Standard (Quarry Face)
- 12.5ton (US)
- Rated Payload - Loose Material (Standard)
- 16ton (US)
- Bucket Capacity Range
- 4.7-13 m3 (6.2-17 yd3)
Buckets
- Bucket Capacities
- 4.7-13 m3 (6.2-17 yd3)
Transmission
- Transmission Type
- Cat switched reluctance electric drive
- Forward 1 (virtual)
- 4.3mile/h
- Forward 2 (virtual)
- 7mile/h
- Forward 3 (virtual)
- 13.8mile/h
- Forward 4 (virtual)
- 20mile/h
- Reverse 1 (virtual)
- 4.3mile/h
- Reverse 2 (virtual)
- 7mile/h
- Reverse 3 (virtual)
- 17.5mile/h
Hydraulic System - Lift/Tilt
- Lift/Tilt System - Circuit
- EH-Positive Flow Control, Flow Sharing
- Lift/Tilt System - Pump
- Variable displacement piston
- Maximum Flow at 1,400-1,600 rpm
- 153gal/min
- Relief Valve Setting - Lift/Tilt
- 4757psi
- Lift Cylinder - Bore
- 8.7in
- Lift Cylinder - Stroke
- 41.3in
- Tilt Cylinder - Bore
- 8.7in
- Tilt Cylinder - Stroke
- 27in
Hydraulic Cycle Times
- Rack Back
- 4.5s
- Raise
- 8s
- Dump
- 2.2s
- Lower Float Down
- 3.5s
- Total Hydraulic Cycle Time
- 18.2s
Hydraulic System - Steering
- Steering System - Circuit
- Pilot, load sensing
- Steering System - Pump
- Piston, variable displacement
- Maximum Flow at 1,400-1,600 rpm
- 71.3gal/min
- Steering Cut Off Pressure
- 4351psi
- Total Steering Angle
- 86°
- Steering Cycle Times - High Idle
- 3.4s
- Steering Cycle Times - Low Idle
- 5.6s
Air Conditioning System
- Air Conditioning
- The air conditioning system on this machine contains the fluorinated greenhouse gas refrigerant R134a (Global Warming Potential = 1430). The system contains 1.8 kg of refrigerant which has a CO2 equivalent of 2.574 metric tonnes.
Axles
- Front
- Fixed
- Rear
- Trunnion
- Oscillation Angle
- 13°
Brakes
- Brakes
- ISO 3450:2011
Operator's Cab
- ROPS/FOPS
- ROPS/FOPS meet ISO 3471:2008 and ISO 3449:2005 Level II standards
Service Refill Capacities
- Fuel Tank
- 147gal (US)
- Cooling System - Jacket Water
- 30gal (US)
- Cooling Systems - Power Train
- 8gal (US)
- Engine Crankcase
- 16gal (US)
- Diesel Exhaust Fluid Tank
- 8.7gal (US)
- Transmission
- 16gal (US)
- Differential - Final Drives - Front
- 49gal (US)
- Differential - Final Drives - Rear
- 49gal (US)
- Hydraulic System - Implement/Steering
- 126gal (US)
- Note
- All nonroad Tier 4 Final/Stage V diesel engines are required to use: – The machine has the flexibility to run on either ultra-low-sulfur diesel fuel (ULSD with 15 ppm of sulfur or less). – Cat engines are compatible with the following renewable, alternati
Sound Performance - Tier 4 Final/EU Stage V - Standard
- Operator Sound Level (ISO 6396)
- 72dB(A)
- Machine Sound Level (ISO 6395)
- 109dB(A)
- Note (1)
- The operator sound pressure level was measured according to the test procedures and conditions specified in ISO 6396:2008. The measurement was conducted at 70 percent of the maximum engine cooling fan speed.
- Note (2)
- Hearing protection may be needed when the machine is operated with a cab that is not properly maintained or when the doors or windows are open for extended periods or in a noisy environment.
- Note (3)
- The machine sound power level was measured according to the test procedures and conditions specified in ISO 6395:2008. The measurement was conducted at 70 percent of the maximum engine cooling fan speed.
Dimensions (Approximate) - Standard Lift
- Ground to Top of ROPS
- 13.8ft
- Ground to Top of Exhaust Stacks
- 14.8ft
- Ground to Top of Hood
- 10.9ft
- Ground to Bumper Clearance
- 3.1ft
- Rear Axle - Centerline to Bumper
- 10.5ft
- Front Axle Centerline to Bucket Tip
- 14ft
- Wheel Base
- 14.9ft
- Maximum Overall Length
- 39.3ft
- Ground to Lower Hitch Clearance
- 1.9ft
- Ground to Center of Axles
- 3.2ft
- Clearance at Maximum Lift
- 11.9ft
- B-Pin Height - Maximum Lift
- 18ft
- Maximum Overall Height - Bucket Raised
- 24.5ft
- Reach - Maximum Lift
- 6.5ft
- Note
- Specs are calculated with 6.9 m3 (9.0 yd3) rock bucket and Michelin XLDD2 with 978 mm (3.2 ft) centerline of rear axle height.
Dimensions (Approximate) - High Lift
- Ground to Top of ROPS
- 13.8ft
- Ground to Top of Exhaust Stacks
- 14.8ft
- Ground to Top of Hood
- 10.9ft
- Ground to Bumper Clearance
- 3.1ft
- Rear Axle - Centerline to Bumper
- 10.5ft
- Front Axle Centerline to Bucket Tip
- 15.3ft
- Wheel Base
- 14.9ft
- Maximum Overall Length
- 40.7ft
- Ground to Lower Hitch Clearance
- 1.9ft
- Ground to Center of Axles
- 3.2ft
- Clearance at Maximum Lift
- 13.3ft
- B-Pin Height - Maximum Lift
- 19.3ft
- Maximum Overall Height - Bucket Raised
- 25.8ft
- Reach - Maximum Lift
- 6.8ft
- Note
- Specs are calculated with 6.9 m3 (9.0 yd3) rock bucket and Michelin XLDD2 with 978 mm (3.2 ft) centerline of rear axle height.
Sustainability
- Recyclability
- 96%
