Specifications
Engine
- Net Power
- 1739HP
- Engine Model
- Cat® 3516E
- Bore
- 6.7in
- Stroke
- 8.5in
- Displacement
- 4766in³
- Rated Speed
- 1,600 rpm
- Emissions
- U.S. EPA Tier 4 Final/EU Stage IV* or U.S. EPA Tier 1/EU Stage I Equivalent
- Gross Power - SAE J1995
- 1870HP
- Peak Torque - 1,200 rpm - SAE J1995
- 8549lb/ft
- Gross Power - ISO 14396
- 1847HP
- Torque Rise
- 39%
- Net Power - SAE J1349 - Standard Ambient
- 1739HP
- Note (4)
- *Tier 4 Final/EU Stage IV configuration is ready to meet Stage V emission requirements once in effect.
- Net Power - SAE J1349 - High Ambient
- 1696HP
- Note (1)
- The power ratings apply when tested under the reference conditions for the specified standard.
- Note (2)
- The net power advertised is the power available at the flywheel when the engine is equipped with fan, alternator, air cleaner, and muffler.
- Note (3)
- The gross power advertised is with the fan at maximum speed.
Operating Specifications
- Operating Weight
- 534852lb
- Bucket Capacity Range
- 17.2 - 43.6 m³ (22.3 - 57 yd³)
- Rated Payload - Standard Lift (Moderate to High Digging Resistance)
- 45ton (US)
- Rated Payload - Standard Lift (Low to Moderate Digging Resistance)
- 60ton (US)
- Rated Payload - High Lift (Moderate to High Digging Resistance)
- 42ton (US)
- Rated Payload - High Lift (Low to Moderate Digging Resistance)
- 55ton (US)
- Bucket Capacity Range - Iron Ore
- 17.2 - 21.4 m³ (22.3 - 28 yd³)
- Bucket Capacity Range - Rock
- 19.1 - 29.1 m³ (25 - 38 yd³)
- Bucket Capacity Range - Coal
- 32.1 - 43.6 m³ (42 - 57 yd³)
- Note
- *In Low to Moderate Digging Resistance: please contact your local dealer to determine if your application is suitable for this increased rated payload
Buckets
- Bucket Capacities
- 19.1-43.6 m3 (25-57 yd3)
Transmission
- Transmission Type
- Cat Planetary Power Shift
- Forward - 1
- 4.6mile/h
- Forward - 2
- 8mile/h
- Forward - 3
- 13.6mile/h
- Reverse - 1
- 5mile/h
- Reverse - 2
- 8.8mile/h
- Reverse - 3
- 14.9mile/h
- Direct Drive - Forward 3
- 15.2mile/h
- Direct Drive - Reverse 3
- 16.8mile/h
- Direct Drive - Reverse 1
- Lock-up disables
- Direct Drive - Forward 2
- 8.7mile/h
- Direct Drive - Reverse 2
- 9.6mile/h
- Direct Drive - Forward 1
- Lock-up disables
- Note
- Travel speeds based on 58/85-57 tires.
Axles
- Front
- Fixed
- Rear
- Trunnion
- Oscillation Angle
- 9°
Hydraulic Cycle Times
- Raise
- 12.6s
- Dump
- 3.1s
- Rack Back
- 4.9s
- Lower Float Down
- 4.2s
- Total Hydraulic Cycle Time - Empty Bucket
- 23.5s
Hydraulic System - Lift/Tilt
- Relief Valve Setting - Lift/Tilt
- 4587psi
- Maximum Flow at 1,700 rpm Engine Speed
- 541gal/min
- Cylinders, Double Acting - Tilt, Bore and Stroke
- 310 × 1086 mm (12.2 × 42.8 in)
- Cylinders, Double Acting - Lift, Bore and Stroke
- 370 × 1713 mm (14.6 × 67.4 in)
- Pilot System
- Open Loop and Pressure Reducing
- Lift/Tilt System - Pump
- Variable Displacement Piston
- Lift/Tilt System - Circuit
- Positive Flow Control
Complete System Fill
- Hydraulic Tank - Steering and Braking
- 100gal (US)
- Transmission
- 110gal (US)
- Fuel Tank - Standard
- 910gal (US)
- Hydraulic Tank - Implement and Hydraulic Fan
- 270gal (US)
- Engine Crankcase
- 76gal (US)
- Cooling System
- 138gal (US)
- Fuel Tank - With 24 hr Attachment
- 1500gal (US)
- Differential - Final Drives - Rear
- 200gal (US)
- Differential - Final Drives - Front
- 220gal (US)
- Oil Renewal System (ORS)*
- 20gal (US)
- Diesel Exhaust Fluid (DEF) (Tier 4 Final/Stage IV)
- 137gal (US)
- Note
- *Not available on Tier 4 Final machines. Not available in all regions.
Sound Performance - Standard
- Operator Sound Level (ISO 6396:2008) - Tier 1/EU Stage I Equivalent
- 72dB(A)
- Machine Sound Level (ISO 6395:2008)
- 119dB(A)
- Operator Sound Level (ISO 6396:2008) - Tier 4 Final/EU Stage IV*
- 72dB(A)
- Sound Performance
- The measurement was conducted at 70 percent of the maximum engine cooling fan speed. Hearing protection may be needed when the machine is operated with a cab that is not properly maintained or when the doors or windows are open for extended periods or in
- Note
- *EU Stage V ready.
Hydraulic System - Steering
- Maximum Flow at 1,700 rpm Engine Speed
- 259gal/min
- Relief Valve Setting - Steering
- 4496psi
- Steering System - Circuit
- Pilot, Load Sensing
- Total Steering Angle
- 80 degrees
- Steering System - Pump
- Piston, Variable Displacement
- Steering Cycle Times - Low Idle
- 7.6s
- Steering Cycle Times - High Idle
- 4.3s
Cooling System
- Ambient Capability Hydraulically Driven Demand Fan - Standard
- 40.8°F
- Ambient Capability Hydraulically Driven Demand Fan - High (Tier 4 Final)
- 127.4°F
- Ambient Capability Hydraulically Driven Demand Fan - High (Tier 1 equivalent)
- 131°F
Dimensions - Standard Lift - Approximate
- Front Axle Centerline to Bucket Tip
- 21.3ft
- Rack Back Angle - Ground Level
- 39.7 degrees
- Clearance at Maximum Lift
- 20.2ft
- Ground to Top of ROPS
- 23.4ft
- Maximum Overall Length
- 64ft
- Maximum Overall Height - Bucket Raised
- 38.6ft
- Reach - Maximum Lift
- 9.3ft
- Rack Angle at Maximum Lift
- 59.5 degrees
- Ground to Top of Exhaust Stacks
- 23.2ft
- Ground to Bumper Clearance
- 4.4ft
- Dump Angle at Maximum Lift
- –50.0 degrees
- Width - Over Tires - With Bulge
- 18.8ft
- Ground to Center of Axles
- 6ft
- Tread Width
- 14.1ft
- Note
- Assumes 22.9 m3 (30 yd3) bucket for standard lift, and 21.4 m3 (28 yd3) bucket for high lift, fitted with Cat Advansys™ heavy duty tips. Assumes tire size 58/85-57.
- B-Pin Height - Maximum Lift
- 28.8ft
- Rack Back Angle - Carry
- 47.7 degrees
- Rear Axle - Centerline to Bumper
- 20.4ft
- Ground to Lower Hitch Clearance
- 2.9ft
- Ground to Top of Hood
- 18.6ft
- Wheel Base
- 22.3ft
Dimensions - High Lift - Approximate
- Rack Back Angle - Carry
- 53.7 degrees
- Reach - Maximum Lift
- 8.8ft
- Ground to Lower Hitch Clearance
- 2.9ft
- Maximum Overall Length
- 66ft
- Ground to Bumper Clearance
- 4.4ft
- Rack Back Angle - Ground Level
- 45.0 degrees
- Tread Width
- 14.1ft
- Clearance at Maximum Lift
- 23.3ft
- Dump Angle at Maximum Lift
- –50.0 degrees
- Rear Axle - Centerline to Bumper
- 20.4ft
- Ground to Center of Axles
- 6ft
- Wheel Base
- 22.3ft
- Maximum Overall Height - Bucket Raised
- 41.2ft
- Ground to Top of Hood
- 18.6ft
- Width - Over Tires - With Bulge
- 18.8ft
- B-Pin Height - Maximum Lift
- 31.7ft
- Ground to Top of Exhaust Stacks
- 23.2ft
- Front Axle Centerline to Bucket Tip
- 23.3ft
- Rack Angle at Maximum Lift
- 59.4 degrees
- Ground to Top of ROPS
- 23.4ft
- Note
- Assumes 22.9 m3 (30 yd3) bucket for standard lift, and 21.4 m3 (28 yd3) bucket for high lift, fitted with Cat Advansys™ heavy duty tips. Assumes tire size 58/85-57.
Sound Performance - Suppression
- Operator Sound Level (ISO 6396:2008) - Tier 4 Final/EU Stage IV*
- 71dB(A)
- Note
- *EU Stage V ready.
- Machine Sound Level (ISO 6395:2008)
- 117dB(A)
- Sound Performance
- The measurement was conducted at 70 percent of the maximum engine cooling fan speed. Hearing protection may be needed when the machine is operated with a cab that is not properly maintained or when the doors or windows are open for extended periods or in
- Operator Sound Level (ISO 6396:2008) - Tier 1/EU Stage I Equivalent
- 71dB(A)
Brakes
- Brakes
- ISO 3450:2011